Information: A/C Distribution Drum Reinforcing Ring
Models: All 1991 thru 1994 - 164
Date: 01/06/94
Back to TSB List
During stepper motor R&R, the installation of a metal securing ring onto the
distribution drum shaft (the female receptacle for the stepper motor) is necessary.
This will prevent possible future breakage of the drum shaft and repair any cracked
or broken drums.
MODELS.
All 1991 thru 1994 - 164
DATE
01/06/94
First, remove The Stepper Motors by following the information given in
T.S.B 8O.93.O2 and by viewing the video p/n 60697496.
After removing of the stepper motors, remove the three tabbed floating plastic place,
located under the stepper motor metal mounting brackets by rotating it clockwise.
With the help of a flashlight. inspect carefully for a crack or any breakage where
the distribution stepper motor
T-
type drive inserts into the drum receptacle. If found only cracked, but intact,
slide metal securing ring over the receptacle while aligning the notches with the
distribution drum flap edge. The metal securing ring must slide completely on, so
as not to hang out beyond the receptacle end.
If the distribution drum female receptacle is found broken. It can be repaired
without dash removal. Repair is done easily by carufuily retrieving
the broken piece with needlenose pliers. Apply a dot of glue to the broken area.
Position the piece to fit properly back in its place of origin. Then proceed with
the installation of the metal ring as explained above.
If receptacle is broken and the piece missing, it is possible to retrieve
it,
Call the Alfa Romeo Technical Hot Line for information on different ways to
access the broken piece without dash removal.
